Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
- 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
   10.2. General information
   + 10.3. Accelerator cable
   10.4. Air filter
   10.5. Casing of the air filter
   10.6. Fuel filter
   10.7. Pressure accumulator
   10.8. Fuel level sensor
   10.9. Fuel pump
   10.10. Fuel tank
   10.11. Throttle case
   10.12. Inlet collector
   - 10.13. Elements of system of injection of KE-JETRONIC fuel
      10.13.1. Fuel distributor
      10.13.2. Sensor of a stream of air
      10.13.3. The air pump (models with six-cylinder engines)
      10.13.4. Valve of cold start of the engine
      10.13.5. The sensor of temperature of cooling liquid
      10.13.6. Switch of provision of a butterfly valve
      10.13.7. Electronic control device (ECU)
      10.13.8. Fuel nozzles
      10.13.9. Pressure regulator
      10.13.10. Additional air device
      10.13.11. Lambda sensor
   10.14. Pressure removal in fuel system
   10.15. Adjustment of turns of idling and the contents WITH in exhaust gases
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






10.13. Elements of system of injection of KE-JETRONIC fuel

GENERAL INFORMATION

Prevention

After replacement of any element of fuel system it is necessary to make diagnostics and testing of fuel system for service stations with use of the special equipment. Thus also information on the damages, written down in memory of the ECU block will be removed.

Gasoline extremely fire - also is explosive, therefore it is necessary to show care at work on any part of fuel system.

Works on fuel system are necessary for making in well aired room for what it is possible to open all windows and doors for draft creation.

At work on fuel system do not use open fire, electric welding and tools, at work with which sparks can be formed. Check that in close proximity to a workplace there is a charged fire extinguisher.

For protection of eyes against fuel hit in them use points. At fuel hit on skin wash out this place a plentiful quantity of water.

The capacity in which there was a fuel, contains pairs of fuel and is potentially explosive.

At work with fuel system observe purity as the dirt which has got to channels of fuel system, can block them that will break normal operation of the engine.