Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
- 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
   10.2. General information
   + 10.3. Accelerator cable
   10.4. Air filter
   10.5. Casing of the air filter
   10.6. Fuel filter
   10.7. Pressure accumulator
   10.8. Fuel level sensor
   10.9. Fuel pump
   10.10. Fuel tank
   10.11. Throttle case
   10.12. Inlet collector
   - 10.13. Elements of system of injection of KE-JETRONIC fuel
      10.13.1. Fuel distributor
      10.13.2. Sensor of a stream of air
      10.13.3. The air pump (models with six-cylinder engines)
      10.13.4. Valve of cold start of the engine
      10.13.5. The sensor of temperature of cooling liquid
      10.13.6. Switch of provision of a butterfly valve
      10.13.7. Electronic control device (ECU)
      10.13.8. Fuel nozzles
      10.13.9. Pressure regulator
      10.13.10. Additional air device
      10.13.11. Lambda sensor
   10.14. Pressure removal in fuel system
   10.15. Adjustment of turns of idling and the contents WITH in exhaust gases
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






10.13.2. Sensor of a stream of air

Removal

Elements of the sensor of measurement of a stream of air and the case of a throttle of the 4-cylinder engine (the six-cylinder is similar)
A–fuel distributor;

B–case of the sensor of measurement of a stream of air;

C–collar of fastening of a rubber pipe;

D–throttle case


PERFORMANCE ORDER
1. Remove the distributor of fuel and a regulator of pressure of fuel.
2. Unscrew bolts and move aside an arm of draft of a throttle.
3. Disconnect the electric socket from the sensor of a stream of air.
4. Weaken a big collar of fastening of a rubber pipe and separate the throttle case from the lower part of the sensor of a stream of air.
5. Unscrew the nuts, fixing the sensor of a stream of air to rubber elements of fastening and arms (see drawing).
6. Remove the sensor of measurement of a stream of air from the case of a throttle and disconnect from it an air hose of turns of idling.
7. Unscrew screws and remove rubber laying from the case of the sensor of measurement of a stream of air. Note an arrangement of screws as they have various length.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Start the engine and check that there are no leaks from earlier acting in film elements. Check and, if necessary, adjust turns of idling and the contents WITH in exhaust gases.