Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
- 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
   10.2. General information
   - 10.3. Accelerator cable
      10.3.2. Installation
      10.3.3. Adjustment
   10.4. Air filter
   10.5. Casing of the air filter
   10.6. Fuel filter
   10.7. Pressure accumulator
   10.8. Fuel level sensor
   10.9. Fuel pump
   10.10. Fuel tank
   10.11. Throttle case
   10.12. Inlet collector
   + 10.13. Elements of system of injection of KE-JETRONIC fuel
   10.14. Pressure removal in fuel system
   10.15. Adjustment of turns of idling and the contents WITH in exhaust gases
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






10.3. Accelerator cable

10.3.1. Removal

GENERAL INFORMATION

Removal of a square fixing element for release of a cable of an accelerator

Extraction of a cable of an accelerator by its transmission through a groove in a lever arm

Arrangement of brackets of fixing of a cover of a cable of an accelerator

Fastening of a cable of an accelerator to an accelerator pedal
A–the lever located in the top part of a pedal of an accelerator;
B–nut of adjustment of a free wheeling of a pedal of an accelerator;
C–sealing ring;
D–a pin for fastening of a returnable spring;
E–accelerator cable

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. In a motor compartment remove an accelerator cable, previously having removed a square fixing element (see fig. Removal of a square fixing element for release of a cable of an accelerator, Extraction of a cable of an accelerator by its transmission through a groove in a lever arm). Take an accelerator cable, having passed it through a groove in a lever arm.
3. Press fixing uvulas and release a cover of a cable of an accelerator from an arm (see fig. Arrangement of brackets of fixing of a cover of a cable of an accelerator).
4. Remove the panel of furnish located under the dashboard from the driver. Remove a returnable spring and disconnect an accelerator cable from the lever of a pedal of an accelerator. Unscrew an adjusting nut, then take an accelerator cable through consolidation перегород ки a motor compartment (see fig. Fastening of a cable of an accelerator to an accelerator pedal).
Prevention

Do not remove a sealing ring of a cable of an accelerator from an internal partition of a motor compartment.


5. On an external partition of a motor compartment remove a sealing ring and take an accelerator cable in a motor compartment.