Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
- 11. System of injection of BOSCH HFM fuel
   11.2. General information
   11.3. Accelerator cable
   11.4. Air filter
   11.5. Casing of the air filter
   11.6. Fuel filter
   11.7. Fuel level sensor
   11.8. Fuel pump
   11.9. Fuel tank
   11.10. Throttle case
   11.11. Inlet collector
   + 11.12. Elements of system of injection of BOSCH HFM fuel
   11.13. Pressure removal in fuel system
   11.14. Adjustment of turns of idling and the contents WITH in exhaust gases
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






11.10. Throttle case

Removal

Throttle case

A–fixing bolts;

B–accelerator cable;

C–cable of management of pressure


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove an inlet collector.
3. Disconnect an accelerator cable from the throttle case. On models with an automatic transmission disconnect a cable of management of pressure from draft of a butterfly valve (see drawing).
4. Mark and disconnect from the throttle case all vacuum hoses
5. Mark and disconnect from the throttle case all electric sockets.
6. At existence unscrew from the basis of the case of a throttle a bracket of fastening of a pipe of an oil radiator.
7. Unscrew bolts of fastening and remove the throttle case from the engine.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Establish and, if necessary, adjust an accelerator cable. On cars with an automatic transmission establish and, if necessary, adjust a cable of management of pressure.