W124 Mercedes + Governing bodies and control devices + MAINTENANCE + 2. Maintenance (diesel engines) + ENGINE + 4. Repair of 6-cylinder petrol SOHC engines + 5. Repair of 6-cylinder petrol DOHC engines + 6. Repair of the diesel engine established in the car + 7. Major maintenance of engines + COOLING SYSTEM + FUEL SYSTEM + 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC) - 11. System of injection of BOSCH HFM fuel 11.2. General information 11.3. Accelerator cable 11.4. Air filter 11.5. Casing of the air filter 11.6. Fuel filter 11.7. Fuel level sensor 11.8. Fuel pump 11.9. Fuel tank 11.10. Throttle case 11.11. Inlet collector + 11.12. Elements of system of injection of BOSCH HFM fuel 11.13. Pressure removal in fuel system 11.14. Adjustment of turns of idling and the contents WITH in exhaust gases + 12. Fuel system of diesel engines + 13. Fuel system of diesel engines + SYSTEMS OF START, IGNITION + 15. System of ignition of 4-cylinder petrol engines + 16. System of ignition of four-cylinder petrol engines + PRESTARTING HEATING + TRANSMISSION + 19. Mechanical transmission + 20. Automatic transmission + POWER SHAFTS + BRAKE SYSTEM + SUSPENSION BRACKET + BODY + ELECTRIC EQUIPMENT + CHECK OF MALFUNCTIONS
|
Removal
Elements of fastening of a cable of an accelerator
|
A–the directing lever of a butterfly valve;
B–element of fastening of a cable of an accelerator;
C–plastic clamp;
D–arm;
E–accelerator pedal; |
F–accelerator cable;
G–adjusting handle;
H–limiter of opening of a butterfly valve;
I–cable of a regulator of pressure |
PERFORMANCE ORDER |
1. In a motor compartment disconnect an accelerator cable from the butterfly valve lever, previously having removed a square fixing element (see drawing). Take an accelerator cable through a groove in the lever. |
2. Compress uvulas of a plastic clamp and remove a cover of a cable of an accelerator from an arm. |
3. Working in car salon, disconnect a returnable spring and remove an accelerator cable from the lever of a pedal of an accelerator. |
4. Unscrew an adjusting nut and take a cover of a cable of an accelerator through consolidation of a partition of a motor compartment.
Prevention
Do not remove a sealing ring from an internal partition of a motor compartment.
|
5. Take an accelerator cable through a partition in a motor compartment. |
|
Installation
PERFORMANCE ORDER |
1. Installation of a cable of an accelerator is made in sequence, return to removal. If necessary check and adjust work of a cable of an accelerator. |
|
Adjustment
PERFORMANCE ORDER |
1. Check that draft and a cable of an accelerator move smoothly and without jammings. If necessary grease draft of an accelerator. |
2. In a starting position of a pedal of an accelerator between a spring on the end of a cable of an accelerator and the plastic block of fastening in the directing lever of a butterfly valve there should be a gap equal 0,5 - 1,0 mm. Otherwise, rotating the adjusting handle, establish a demanded gap. |
3. At replacement of a cable of an accelerator usually it is not required to make adjustment of drafts of a butterfly valve. If it is required, adjustment of drafts of a butterfly valve is necessary for making at service station as it is very difficult operation. |
|
|
|