Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
- 13. Fuel system of diesel engines
   13.2. General information
   13.3. Catching system паров fuels
   13.4. System of ventilation of a case
   13.5. Final collector
   13.6. System of repeated burning of exhaust gases (EGR)
   13.7. Turbonagnetatel
   13.8. Exhaust system
   13.9. Katalichesky converter
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






13.3. Catching system паров fuels

GENERAL INFORMATION

The catching system паров fuels consists of the valve of cleaning, the thermovalve, one or two coal canisters and connecting hoses.

The valve of cleaning is located in a back part of a motor compartment on the left side of a partition. The canister with coal is established under an arch of the left forward wheel.

CLEANING VALVE

Removal

PERFORMANCE ORDER
1. Mark and disconnect from the cleaning valve vacuum hoses.
2. Release the cleaning valve from a bracket of fastening and take it from a motor compartment.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.

THERMOVALVE

Removal

PERFORMANCE ORDER
1. The thermovalve is established on the left side of a head of the block of cylinders.
2. Work on removal of the thermovalve make on the cold engine. Partially merge cooling liquid.
3. Disconnect from the thermovalve vacuum hoses and unscrew the thermovalve from a head of the block of cylinders. Remove a sealing ring.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. At installation of the thermovalve it is necessary to use a new sealing ring.