Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
- SYSTEMS OF START, IGNITION
   14.2. General information
   14.3. Rules of care of the accumulator
   14.4. Accumulator check
   14.5. Battery charging
   14.6. Accumulator
   14.7. Charging system
   14.8. Generator
   14.9. Replacement of the block of a regulator of tension and shchetkoderzhatel
   14.10. System of start of the engine
   14.11. Starter
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






14.11. Starter

GENERAL INFORMATION

On all models the starter fastens bolts to a coupling case on the left back part of the engine. Access to a starter is possible from under the car. On models with diesel engines about heat exchange anybody engine oil process of removal of a starter much more difficult and demands an engine raising.

Removal

ALL MODELS WITH PETROL ENGINES AND MODELS WITH DIESEL ENGINES WITHOUT THE HEAT EXCHANGER OF ENGINE OIL

Starter extraction from a nest in a coupling case

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator. Lift a forward part of the car and fix on supports.
2. Remove an engine mudguard from a forward part of a motor compartment.
3. Remove the air filter. Unscrew and remove an arm of support of an inlet collector.
4. In the lower part of the oil pallet unscrew an arm of fastening of a directing hose and move a hose aside.
5. From a back part of the traction relay unscrew nuts and screws and disconnect electric wires from the traction relay.
6. Turn a steering wheel against the stop to the right and check that the left pendular lever is at the maximum distance from a starter. On diesel models with a turbo-supercharging disconnect the central steering draft from the left pendular lever.
7. Unscrew nuts and take the top and bottom bolts of fastening of a starter.
8. Take a starter from a nest of a case of coupling and get it from a motor compartment (see drawing).

MODELS WITH DIESEL ENGINES WITH THE OIL HEAT EXCHANGER

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator. Lift a forward part of the car and fix on supports.
2. Remove a mudguard from the lower part of a motor compartment.
3. Remove the air filter. Unscrew and remove an arm of support of an inlet collector.
4. Hook on slings of the load-lifting mechanism for elevating eyes of the engine. Raise the load-lifting mechanism so that the weight of the engine was perceived by the load-lifting mechanism. From two parties of the engine unscrew the bottom bolts of fastening of support of the engine.
5. Raise the engine to provide space for starter removal.
6. Unscrew nuts and take bolts of the top and bottom fastening of a starter.
7. Take a starter from a nest of a case of coupling and get it from a motor compartment.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.