Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
- SYSTEMS OF START, IGNITION
   14.2. General information
   14.3. Rules of care of the accumulator
   14.4. Accumulator check
   14.5. Battery charging
   14.6. Accumulator
   14.7. Charging system
   14.8. Generator
   14.9. Replacement of the block of a regulator of tension and shchetkoderzhatel
   14.10. System of start of the engine
   14.11. Starter
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






14.6. Accumulator

Removal

Arrangement of the screws, fixing accumulator plugs

Arrangement of a bolt of fastening of the accumulator

PERFORMANCE ORDER
1. Weaken fastening and remove the negative plug of the accumulator.
2. Remove a protective cover, weaken fastening and remove the positive plug from the accumulator (see fig. An arrangement of the screws, fixing accumulator plugs).
3. In the lower part of the accumulator unscrew a bolt and remove a plate of fastening of the accumulator (see fig. Arrangement of a bolt of fastening of the accumulator).
4. Take the accumulator from a motor compartment.

Installation

PERFORMANCE ORDER
1. Installation of the accumulator is made in sequence, return to removal.
2. Thus at first connect the positive plug of the accumulator, and then negative. After connection by glue to the accumulator grease them with technical vaseline.