Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
- SYSTEMS OF START, IGNITION
   14.2. General information
   14.3. Rules of care of the accumulator
   14.4. Accumulator check
   14.5. Battery charging
   14.6. Accumulator
   14.7. Charging system
   14.8. Generator
   14.9. Replacement of the block of a regulator of tension and shchetkoderzhatel
   14.10. System of start of the engine
   14.11. Starter
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






14.8. Generator

GENERAL INFORMATION

On all models the generator is established from the right forward party of the engine and is put in action by an auxiliary driving belt.

On models with 4-cylinder and 6-cylinder petrol SOHC engines the generator can be removed from the engine from the top part of a motor compartment. On models with 6-cylinder petrol DOHC engines and all diesel engines the generator can be removed only from under the car.

Removal

Arrangement of a clamp of the multicontact socket of the generator

Places of connection of electric wires to the generator of the reduced sizes

Arrangement of bolts of fastening of the generator

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator. If necessary lift a forward part of the car and fix on supports.
2. Remove the mudguard of the engine located in the lower part of a motor compartment. For improvement of access remove tubes of supply of air in the engine.
3. Remove an auxiliary driving belt from a generator pulley.
4. Unscrew bolts and remove a plastic cover from a back part of the generator. Press clamps and disconnect многоконтак the tny electric socket from the generator (see fig. Arrangement of a clamp of the multicontact socket of the generator).
5. On models with the generator of the reduced sizes remove a rubber protective cover, unscrew nuts and disconnect generator wires from plugs (see fig. Places of connection of electric wires to the generator of the reduced sizes).
6. Unscrew top, then bottom bolts of fastening of the generator and remove the generator from an arm (see fig. Arrangement of bolts of fastening of the generator).
7. If necessary remove the block of a regulator of tension and a shchetkoderzhatel.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Establish an auxiliary driving belt and adjust its tension.