1. Remove the generator. |
2. Establish the generator on a desktop a pulley down. |
3. On the generator of the reduced sizes unscrew screws, release clamps and remove plastic a casing from a back part of the generator. |
4. Unscrew screws of fastening of the block of a regulator of tension and a shchetkoderzhatel and take the block from the generator (see fig. Arrangement of screws of fastening of the block of a regulator of tension and shchetkoderzhatel, Extraction of the block of a regulator of tension and shchetkoderzhatel). |
5. Measure length of brushes of the generator in a free condition from a brand of the manufacturer located sideways, to brush edge. If length of brushes less admissible, replace the block of a regulator of tension and a shchetkoderzhatel. |
6. Check a condition of a surface of contact rings of the generator. At existence on contact rings рисок and scratches polish contact rings with использова niy a fine-grained emery paper. |
7. Collect the generator in sequence, return dismantling. |
8. Establish the generator on the car. |