Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
- TRANSMISSION
   18.2. General information
   18.3. Coupling knot
   18.4. Lever of switching off of coupling and vyzhimny bearing
   18.5. Working cylinder of coupling
   - 18.6. Main cylinder of coupling
      18.6.1. Removal
      18.6.2. Dismantling and assembly
      18.6.3. Installation
      18.6.4. Pusher adjustment
   18.7. Air removal from hydraulic system of coupling
   18.8. Coupling pedal
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






18.6.4. Pusher adjustment

GENERAL INFORMATION

Adjustment of a pusher of the main cylinder of coupling

1–metal plates in the sizes 60 x 20 x 1 of mm;

2–screw;

3–adjusting screw


PERFORMANCE ORDER
1. For access to the working cylinder of coupling lift a forward part of the car and fix on supports. Using a pure syringe, pump out a half of liquid of the corresponding chamber of a tank for brake system.
2. Insert some metal strips with the sizes 60 x 20 x 1 of mm between the top limiter of a course of a pedal of coupling and a rubber pillow (see drawing).
3. Remove a dustproof cap and clear dirt round the union of pumping of the working cylinder of coupling.
4. Establish a tube on the pumping union, and the second end of a tube connect to the special equipment for air removal under pressure.
5. A wrench unscrew the pumping union on a turn half.
6. Working in car salon for pedals, weaken tightening the screw located on the ekstsentrikovy adjusting screw of a pusher on a pedal of coupling.
7. The assistant should watch constantly level of brake liquid in a popolnitelny tank of brake system.
8. Slowly turn the clown the vy adjusting screw until level of brake liquid will not start to increase. Then slowly turn the adjusting screw in the opposite direction before situation at which level of brake liquid remains on a place.
9. In this situation fix the adjusting screw, having tightened tightening the screw.
10. Take the metal strips previously inserted between the top limiter of a course of a pedal of coupling and a rubber pillow. Thus level of brake liquid in a popolnitelny tank should rise.
11. Tighten the union of pumping and disconnect a hose and the special equipment for air removal under pressure. Establish on the pumping union a dustproof cap.
12. Add brake liquid in a popolnitelny tank of brake system.
13. Start the engine and check coupling work.
14. Establish the bottom furnish of the dashboard from the driver.