Mercedes W124

since 1985-1995 of release

Repair and car operation


W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
- TRANSMISSION
   18.2. General information
   18.3. Coupling knot
   18.4. Lever of switching off of coupling and vyzhimny bearing
   18.5. Working cylinder of coupling
   + 18.6. Main cylinder of coupling
   18.7. Air removal from hydraulic system of coupling
   18.8. Coupling pedal
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






18.8. Coupling pedal
GENERAL INFORMATION

Elements of fastening of pedals of coupling and brake to an arm

Removal

Elements of fastening of a pedal of a brake

A–шплинт;
B–a pin with a head;
C–electric socket of the switch of a stoplight;
D–arm of a returnable spring

Arrangement of nuts of fastening of pedals to a partition of a motor compartment

Arrangement of a bolt of fastening of an arm of pedals to the top part of a partition of a motor compartment

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove furnish of the lower part of the dashboard from the driver.
3. Unbend a carpet under pedals and close a floor rags for collecting the liquid which has flowed out from hydraulic system of coupling.
4. For reduction of losses of liquid, using a pure syringe, pump out the maximum quantity of liquid from the corresponding chamber of a tank of brake system so that level of liquid fell below connection of a submitting hose of the main cylinder of coupling.
5. Being careful, remove a returnable spring of a pedal of a brake (see fig. Elements of fastening of a pedal of a brake).
6. Disconnect the electric socket from the stoplight switch, then remove the stoplight switch from an arm.
7. Take шплинт from a pin connecting a pedal of a brake to a pusher of the vacuum amplifier of brakes, then take a pin.
8. Unscrew four nuts of fastening of an arm of pedals to a forward part of a partition of a motor compartment and a bolt, a fixing arm to a forward part of a partition (see fig. An arrangement of nuts of fastening of pedals to a partition of a motor compartment, the Arrangement of a bolt of fastening of an arm of pedals to the top part of a partition of a motor compartment).
Prevention

The nuts, fixing an arm of pedals, also fix the vacuum amplifier of brakes.
9. Move an arm of pedals from a partition of a motor compartment, remove it from racks, lower down and disconnect a hose from the main cylinder of coupling.
10. Take an arm with pedals from car salon.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal taking into account the next moments.
2. Check and, if necessary, adjust position of the switch of stoplights.
3. Remove air from hydraulic system of coupling.