Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
- 19. Mechanical transmission
   19.2. General information
   19.3. Oil replacement in a transmission
   19.4. Gear shifting mechanism
   19.5. Replacement of sealing rings
   19.6. Switch of light of a backing
   19.7. Removal and transmission installation
   19.8. Transmission repair
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






19.3. Oil replacement in a transmission

GENERAL INFORMATION

Prevention

For unscrewing of a stopper of filling / check of level of oil and a stopper plum of oil it is necessary to use a six-sided key.


Unscrewing of a stopper of filling / check of level of oil in a mechanical transmission

Stopper arrangement oil plum from a mechanical transmission

PERFORMANCE ORDER
1. Establish the suitable container under a stopper oil plum from a transmission, located in the lower part of a case of a transmission. For acceleration oil plum from a transmission on the right side unscrew a stopper of check of level / filling of oil. Unscrew a stopper oil plum from a transmission and if it is necessary, press a stopper when unscrew that oil did not proceed prematurely. For unscrewing of jams use of a shestigrannik is necessary, but instead of it it is possible to use the corresponding extended nut or a piece of a shestigrannik and a wrench (see fig. Unscrewing of a stopper of filling / check of level of oil in a mechanical transmission, a stopper Arrangement oil plum from a mechanical transmission).
2. When oil completely will flow down, wipe everything round a drain opening a rag and reliably screw up a stopper with a new sealing ring into place.
3. Fill in in a transmission oil of demanded type to the bottom level of a jellied opening. A finger check, whether reaches level of oil of edge of an opening and, if necessary, add oil. When filling oil substitute capacity for collecting following oil. Do not fill in too much oil at one time.
4. Screw up a stopper of filling and check of level of oil.