Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
- 19. Mechanical transmission
   19.2. General information
   19.3. Oil replacement in a transmission
   19.4. Gear shifting mechanism
   19.5. Replacement of sealing rings
   19.6. Switch of light of a backing
   19.7. Removal and transmission installation
   19.8. Transmission repair
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






19.8. Transmission repair

GENERAL INFORMATION

The transmission represents very difficult unit and its repair it is necessary to make in a specialized workshop. Also at removal and installation of many details it is necessary to measure gaps and, if necessary, to adjust them for what use of the corresponding adjusting laying and washers is necessary. Not only that details of a transmission are absent on sale and they are necessary for ordering, they are still extremely expensive. If the transmission is faulty or works with strong noise, it is desirable to charge repair of a transmission to the expert or to replace a transmission that can cost cheaper considerably. However the part of malfunctions of a transmission can be eliminated without removal of a transmission from the car.

However, despite all difficulties, the skilled expert can make repair of a transmission and in house conditions. Thus it is necessary to have special tools and to perform work consistently, step by step noting the executed operations. At repair of a transmission it is necessary to use special flat-nose pliers for removal of lock rings, strippers for bearings, an inertial hammer, a set of punches, a micrometer and a hydraulic press.

Before removal of a transmission try to define most precisely malfunction of a transmission that further considerably will facilitate repair.