Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
- 20. Automatic transmission
   20.2. General information
   20.3. Selector lever
   20.4. Draft of a choice of transfers
   + 20.5. Adjustment of a cable of management by pressure
   + 20.6. Switches of blocking of a starter and backing lamps
   + 20.7. Removal and installation of an automatic transmission
   20.8. Repair of an automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






20.3. Selector lever

Removal

Removal of a bracket of fastening of bent for to the selector lever

Arrangement of screws of fastening of the lever of the selector

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Tighten the hand brake, then lift a forward part of the car and fix on supports.
3. Working under the car, remove a bracket of fastening and disconnect draft from the lower part of the lever of the selector (see fig. Removal of a bracket of fastening of bent for to the selector lever).
4. Remove decorative slips from the top part of the central console. On later models, probably, it is required to remove all central console.
5. Disconnect the electric socket from the indicator of illumination of the included transfer or take an illumination bulb from a casing of the lever of the selector.
Disconnect the electric socket from the switch of a mode of movement.
Unscrew screws of fastening and remove the selector lever, lowering it under the car (see fig. Arrangement of screws of fastening of the lever of the selector). Remove laying.

Installation

PERFORMANCE ORDER
1. Check a condition of laying and, if necessary replace it.
2. Establish laying on knot of the lever of the selector, then insert fastening screws in order that laying was not displaced at installation.
3. Further installation is made in sequence, return to removal.