Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
- 20. Automatic transmission
   20.2. General information
   20.3. Selector lever
   20.4. Draft of a choice of transfers
   + 20.5. Adjustment of a cable of management by pressure
   + 20.6. Switches of blocking of a starter and backing lamps
   + 20.7. Removal and installation of an automatic transmission
   20.8. Repair of an automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






20.4. Draft of a choice of transfers

Adjustment

Adjustment of length of draft of a choice of transfers
A–handle of the lever of the selector;
B–selector lever;
C–lock-nut of draft of a choice of transfers;
D–draft of a choice of transfers;
E–the lever of a choice of transfers on a transmission

PERFORMANCE ORDER
1. At adjustment of draft of a choice of transfers the car should stand on wheels.
2. Working under the car, remove a fixing bracket and remove draft of a choice of transfers from the lower part of the lever of the selector (see fig. Removal of a bracket of fastening of bent for to the selector lever file 20.3).
3. Establish the selector lever in situation N.
4. Weaken a lock-nut on the end of draft of a choice of transfers (see fig. Adjustment of length of draft of a choice of transfers).
5. Turning a tip, adjust length of draft of a choice of transfers so that at connection of draft and the lever there was a gap about 1 mm between the lever of the selector and N ledge on the panel of a choice of transfers.
After adjustment establish draft of a choice of transfers on the lever of the selector and fix a fastening bracket then tighten a lock-nut.

Removal

PERFORMANCE ORDER
1. Tighten the hand brake, then lift a forward part of the car and fix on supports.
2. Remove the fastening brackets, fixing bent for to the lever of the selector and the lever of a choice of transfers on a transmission and take draft from under the car.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.