Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
- 20. Automatic transmission
   20.2. General information
   20.3. Selector lever
   20.4. Draft of a choice of transfers
   - 20.5. Adjustment of a cable of management by pressure
      20.5.2. Four-cylinder petrol engines with system of injection of fuel
      20.5.3. 6-cylinder engines (SOHC and diesel engines with a turbo-supercharging)
      20.5.4. Six-cylinder petrol DOHC engines
      20.5.5. Other diesel engines
   + 20.6. Switches of blocking of a starter and backing lamps
   + 20.7. Removal and installation of an automatic transmission
   20.8. Repair of an automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






20.5.3. 6-cylinder engines (SOHC and diesel engines with a turbo-supercharging)

Models with a regulator on a cable cover

Adjustment of length of a cable of management by pressure on 6-cylinder petrol SOHC engines and 6-cylinder diesel engines with a turbo-supercharging

A–cable tip;

B–a regulator on a cable cover


PERFORMANCE ORDER
1. Remove the end of a cable of management of pressure from the spherical hinge of draft of a butterfly valve.
2. Extend a cable forward before emergence of notable resistance.
3. In this situation establish the cable end on the spherical hinge of draft of a butterfly valve. If length of a cable too big or too small, rotate a regulator of a cover of a cable until the end of a cable will not be combined with the spherical hinge (see drawing).

Models with the index and an adjusting wheel

PERFORMANCE ORDER
1. Rotating a regulator wheel, establish a regulator in such situation that the gap between a tip of a cable and the plug of a regulator made 1 mm.
2. Turn a regulator wheel in the opposite direction before combination of the index of a regulator with a flute in the wheel center.