Mercedes W124

since 1985-1995 of release

Repair and car operation


W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
- 20. Automatic transmission
   20.2. General information
   20.3. Selector lever
   20.4. Draft of a choice of transfers
   + 20.5. Adjustment of a cable of management by pressure
   + 20.6. Switches of blocking of a starter and backing lamps
   - 20.7. Removal and installation of an automatic transmission
      20.7.2. Installation
   20.8. Repair of an automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS



трубы купить

20.7.2. Installation
PERFORMANCE ORDER
1. Establish the hydrotransformer as follows:

– apply a thin film greasings on a flange of a drive of the hydrotransformer;
– using the additional handles screwed on the hydrotransformer, establish it into place. At installation of the hydrotransformer turn it in the parties both several times raise up and down in order that teeths of the hydrotransformer incorporated to entrance shaft of a transmission;
– insert a plastic clamp on a place and turn it on a turn quarter clockwise. On models with 4-and 5-cylinder diesel engines fix a gidrotransfor the motor, having inserted a steel core into an opening for liquid plum from the hydrotransformer;
– turn the hydrotransformer in such situation that two openings under bolts of fastening of the hydrotransformer to a plate of a drive settled down in the lower part of a transmission.

2. A jack through a wooden bar lift a transmission into place.
3. Move a transmission before connection of a case of a transmission with the block of cylinders.
4. Fix bolts a transmission to the engine, thus establish tire of grounding and arms which fasten these bolts.
5. Screw in fastening bolts a formator hydrotrance to a plate of a drive and tighten them the demanded moment. For access to each subsequent pair of bolts turn a cranked shaft of the engine.
6. Further installation is made in sequence, return to removal taking into account the next moments.
7. At installation of pipes of the heat exchanger of transmission liquid use new sealing rings.
8. Connect the driveshaft to a transmission flange.
9. Check correctness of connection to a transmission of electric sockets and vacuum hoses.
10. Establish an exhaust system.
11. Fill in in a transmission transmission this liquid.
12. Check and, if necessary, adjust a cable of management of pressure.