Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
- POWER SHAFTS
   21.2. General information
   21.3. Oil replacement in reverse main gear
   21.4. Removal and installation of reverse main gear
   21.5. Replacement of sealing rings of reverse main gear
   21.6. Power shafts
   21.7. Replacement of protective covers of CV JOINTS of a power shaft
   21.8. Driveshaft
   21.9. Rubber elastic coupling of the driveshaft
   21.10. Central bearing of the driveshaft
   21.11. Universal hinge of the driveshaft
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






21.3. Oil replacement in reverse main gear

GENERAL INFORMATION

Stopper unscrewing oil plum from reverse main gear

PERFORMANCE ORDER
1. Make a trip on sufficient distance for warming up of reverse main gear to normal working temperature.
2. Establish the car in horizontal situation over a viewing hole.
3. Wipe area about a stopper of filling / level of oil in the reverse main gear located on the left side, and unscrew a stopper.
4. Establish under the drain stopper located on the right side of a case of reverse main gear, the suitable container and unscrew a stopper (see drawing).
5. Merge oil in the container. Clear jams and remove metal particles from the magnets fixed on jams.
6. After plum of oil clear a carving of a drain stopper and establish a drain stopper into place, having tightened it the demanded moment.
7. Fill in in the main reverse gear exact amount of demanded oil and check oil level. If precisely demanded amount of oil is filled in, and level of oil is higher than norm, establish a stopper of checking of level of oil and make a short trip in order that oil was distributed between all elements of reverse main gear. Repeatedly check level of oil and, if necessary, finish it to norm.