Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
- BRAKE SYSTEM
   22.2. General information
   22.3. Pumping of hydraulic brake system
   22.4. Brake pipelines and hoses
   + 22.5. Replacement of forward brake shoes
   22.6. Replacement of back brake shoes
   22.7. Forward brake disk
   22.8. Back brake disk
   22.9. Forward brake support
   + 22.10. Support repair
   22.11. Back brake support
   22.12. Main brake cylinder
   22.13. Vacuum amplifier of brakes
   22.14. Unilateral valve of the vacuum amplifier of brakes
   22.15. Adjustment of the parking brake
   22.16. Brake shoes of the parking brake
   22.17. Pedal of the parking brake
   22.18. Cables of the parking brake
   22.19. Stoplight switch
   22.20. Anti-blocking system (ABS)
   + 22.21. Elements of anti-blocking system
   22.22. The vacuum pump on models with diesel engines
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






22.19. Stoplight switch

Removal

Arrangement of a bracket of fastening (1) switch of a stoplight
At installation a rod of the switch (2) put forward on the maximum distance.

PERFORMANCE ORDER
1. Remove the bottom furnish of the dashboard from the driver.
2. Disconnect the electric socket from the stoplight switch.
3. Press blocking bracket, then turn the switch of a stoplight and take it from a pedal arm (see drawing).

Installation

PERFORMANCE ORDER
1. Before installation of the switch of a stoplight a rod of the switch put forward on the maximum distance.
2. Press a brake pedal against the stop and fix it in this situation. Insert the stoplight switch into an arm before fixing it a fixing bracket. Slowly release a brake pedal in a starting position. Thus there will be an automatic adjustment of the switch of a stoplight.
3. Connect the electric socket to the switch of a stoplight and check its work. The switch should include the bulbs of a stoplight located in back lamps, after moving of a pedal of a brake on 5 mm. If the switch does not work, as it is required, means, it is faulty, and it is necessary to replace it.
4. Establish furnish of the lower part of the dashboard from the driver.