Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
- ENGINE
   3.2. General data
   3.3. Repair operations on the engine established in the car
   3.4. Check of pressure of compression
   3.5. Top dead point (VMT) of the piston of the first cylinder
   3.6. Cover of a head of the block of cylinders
   3.7. Pulley cranked shaft / quencher of krutilny fluctuations and nave
   + 3.8. Cover of a driving chain
   3.9. Check and replacement of a driving chain
   + 3.10. Mechanism of a tension of a driving chain, asterisk and uspokoitel of a chain
   3.11. Intermediate shaft
   + 3.12. Drive of valves, pushers and camshaft
   + 3.13. Head of the block of cylinders
   3.14. Oil pallet
   3.15. Oil pump
   3.16. Drive flywheel / plate
   3.17. Replacement of sealing rings of a cranked shaft
   3.18. Bearing replacement in an end face of a cranked shaft
   3.19. Check and replacement of a support of the power unit
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






3.18. Bearing replacement in an end face of a cranked shaft

GENERAL INFORMATION

On models with a mechanical transmission in an end face of a cranked shaft from a flywheel the bearing on which the entrance shaft of a transmission leans is established.

Bearing arrangement in an end face of a cranked shaft

1–flywheel;

2–cranked shaft;

3–bearing;

4–remote plug


PERFORMANCE ORDER
1. Remove a flywheel and coupling.
2. Remove a lock ring and, using an inertial hammer with special captures, take the bearing from an end face of a cranked shaft.
3. Clear a nest for the bearing in an end face of a cranked shaft.
4. Put on an external ring of the bearing a thin layer of special glue.
5. Using the tubular opravka leaning on an external ring of the bearing, establish the bearing in a nest of a cranked shaft against the stop and fix a lock ring.
6. Establish coupling and a flywheel.