Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
- ENGINE
   3.2. General data
   3.3. Repair operations on the engine established in the car
   3.4. Check of pressure of compression
   3.5. Top dead point (VMT) of the piston of the first cylinder
   3.6. Cover of a head of the block of cylinders
   3.7. Pulley cranked shaft / quencher of krutilny fluctuations and nave
   + 3.8. Cover of a driving chain
   3.9. Check and replacement of a driving chain
   + 3.10. Mechanism of a tension of a driving chain, asterisk and uspokoitel of a chain
   3.11. Intermediate shaft
   + 3.12. Drive of valves, pushers and camshaft
   + 3.13. Head of the block of cylinders
   3.14. Oil pallet
   3.15. Oil pump
   3.16. Drive flywheel / plate
   3.17. Replacement of sealing rings of a cranked shaft
   3.18. Bearing replacement in an end face of a cranked shaft
   3.19. Check and replacement of a support of the power unit
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






3.2. General data

The engine with four cylinders rowed with one top camshaft.

The cranked shaft leans on five radical bearings. Persistent half rings for adjustment axial люфта a cranked shaft are established on the third radical bearing.

In the bottom heads of a rod shatunny loose leaves are established. Pistons fasten to rods piston fingers. Pistons are made of an aluminum alloy and have three piston rings, two sealing and one maslosjemny.

The camshaft located in the top part of a head of the block of cylinders is put in action by a single-row or dvukhryadny chain. The chain also puts in action an intermediate shaft which is used for a drive of the distributor of ignition and the fuel pump on carburetor models.

The camshaft leans on five bearings and operates valves through yokes and hydraulic pushers.

Greasing of the engine is made under the pressure created by the oil pump which is given directly from a cranked shaft and is placed in a cover of a driving chain.