Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
- 5. Repair of 6-cylinder petrol DOHC engines
   5.2. General information
   5.3. Repair operations on the engine established in the car
   5.4. Check of pressure of compression
   5.5. Top dead point (VMT) of the piston of the first cylinder
   5.6. Cover of a head of the block of cylinders
   5.7. Pulley cranked shaft / quencher of krutilny fluctuations and nave
   + 5.8. Covers of a driving chain
   5.9. Check and replacement of a driving chain
   + 5.10. Mechanism of a tension of a driving chain, asterisk and uspokoitel of a chain
   5.11. Boot of the mechanism of a tension
   5.12. Mechanism of adjustment of a camshaft
   5.13. Camshafts and pushers
   5.14. Check and adjustment of provision of camshafts
   5.15. Head of the block of cylinders
   5.16. Oil pallet
   5.17. Oil pump chain and drive
   5.18. Drive flywheel / plate
   5.19. Replacement of sealing rings
   5.20. Bearing replacement in an end face of a cranked shaft
   5.21. Check and replacement of a support of the power unit
   5.22. Oil radiator
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






5.11. Boot of the mechanism of a tension

Removal

Removal of a boot of the mechanism of a tension of a driving chain

PERFORMANCE ORDER
1. Establish the piston of the first cylinder in VMT and check that all adjusting labels were combined with indexes.
2. Remove the bottom cover of a driving chain.
3. Put combination labels on a driving chain and an asterisk of a cranked shaft.
4. Turn a boot of the mechanism of a tension and remove it from a sharnirny finger (see fig. Removal of a boot of the mechanism of a tension of a driving chain).

Check

Release of brackets of fixing of a boot of the mechanism of a tension of a chain

The plastic detail contacting to a driving chain
Remove from a boot the plastic detail contacting to a driving chain.

PERFORMANCE ORDER
1. Check a boot condition on lack of wear, damages or cracks. At wear of the plastic surface contacting to a driving chain, it is possible to replace it separately after release of brackets of fixing (see fig. Release of brackets of fixing of a boot of the mechanism of a tension of a chain, the Plastic detail contacting to a driving chain).

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.