Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
- 7. Major maintenance of engines
   7.2. General information
   7.3. Recommendations about engine removal
   7.4. Removal and installation of 4-cylinder petrol engines
   7.5. Removal and installation of 6-cylinder petrol engines
   7.6. Removal and installation of diesel engines
   7.7. Sequence of dismantling of the engine
   + 7.8. Analysis of a head of the block of cylinders
   + 7.9. Assembly of a head of the block of cylinders
   7.10. Removal of pistons with rods
   7.11. Removal of a cranked shaft
   7.12. Block of cylinders of the engine
   7.13. Pistons and rods
   7.14. Cranked shaft
   7.15. Survey of radical and shatunny bearings
   7.16. Engine balance of assembly at major maintenance
   7.17. Installation of piston rings
   7.18. Installation of a cranked shaft
   7.19. Check of a working gap of radical bearings
   7.20. Installation of a cranked shaft
   + 7.21. Installation of pistons with rods
   7.22. Engine start after major maintenance
+ COOLING SYSTEM
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






7.16. Engine balance of assembly at major maintenance

GENERAL INFORMATION

Installation of a casing of the oil filter
At installation of a casing of the oil filter it is necessary to use new laying.

Installation of the water pump
At installation of the water pump it is necessary to use a new sealing ring of round section.

Assembly of the engine should be executed in the following order:

– cranked shaft;
– pistons and rods;
– oil pump;
– oil pallet;
– drive flywheel / plate;
– head of the block of cylinders;
– driving chain, mechanism of a tension of a chain and asterisk;
– hinged knots.