1. Remove a head of the block of cylinders. |
2. Remove inlet and final collectors. |
3. Remove the mechanism of a drive of valves, hydraulic pushers and a camshaft. |
4. Unscrew spark plugs. |
5. Unscrew a thermostat casing from a head of the block of cylinders. |
6. Using the adaptation for compression of a spring of the valve, compress each spring and remove crackers from a valve end face. Remove the adaptation for compression of a spring and take a plate of a spring and a spring. On early models on each valve were established on two springs. |
7. Being careful, flat-nose pliers remove from a valve rod a maslootrazhatelny cap. |
8. When the spring of the valve is compressed and the cup of a spring does not act in film from crackers, it is necessary to strike with a hammer through wooden whetstone on a spring cup that will lead to release of crackers. |
9. Take the valve via the combustion chamber. Each valve store in a separate plastic bag together with a plate of a spring, a spring, a nest of a spring and crackers for their further installation on the places. |