1. Grease cores of valves with pure engine oil and insert them on the places. The valve establish on those places where they were ground in. |
2. Establish a spring nest. Lower a maslootrazhatelny cap in fresh engine oil and establish it on a valve core into place, being careful not to damage it working edges. For protection of working edges of a maslootrazhatelny cap before installation it is possible to wind with a sticky tape an end face of a core of the valve. |
3. Establish a klapanny spring and a plate of a spring. |
4. The special adaptation compress a klapanny spring and establish crackers in dredging of a core of the valve and grease them. Remove the adaptation for spring compression. Repeat this operation on other valves. |
5. With a hammer through wooden whetstone knock on an end face of a core of the valve in order that all elements of the valve were accurately established on the places. |
6. Establish on a head of the block of cylinders a thermostat casing. |
7. Screw in spark plugs. |
8. Establish a camshaft and the mechanism of a drive of valves with hydraulic pushers. |
9. Establish inlet and final collectors. |
10. Establish a head of the block of cylinders (look the corresponding description in subsection 4.12). |