Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
- COOLING SYSTEM
   8.2. General information
   8.3. Hoses of system of cooling
   8.4. Radiator
   8.5. Thermostat
   + 8.6. Radiator fan
   8.7. Electric sensors
   + 8.8. Water pump
   8.9. Heating and ventilation system
   - 8.10. Elements of system of heating
      8.10.2. Heater radiator
      8.10.3. Control panel heater
      8.10.4. Engine of the fan of a heater
      8.10.5. Internal sensor of temperature
      8.10.6. Sensors of temperature of a radiator of a heater
      8.10.7. Switch of distribution of air and cable
      8.10.8. Regulator of size of an air stream
   8.11. Air central air
+ FUEL SYSTEM
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






8.10.7. Switch of distribution of air and cable

Removal

PERFORMANCE ORDER
1. Remove the control unit a heater.
2. Disconnect an arm of fastening of the switch on the console.
3. Move the switch lever to the right, release it from a nest, then take the switch block.
4. Disconnect a management cable from the basis of the block of the switch and unscrew fastening nuts.
5. Disconnect the electric socket from a back part of the block of the switch.
6. Remove the panel of furnish located under a ware box and a ware box.
7. Under the dashboard remove a management cable under the lever of the top and bottom folding shutters.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Adjust the switch for what turn the switch in the provision of 9 hours and rotate adjusting nuts on connection of a cable of management in a back part of the switch until the bottom and top folding shutters will not be closed completely.