Mercedes W124

since 1985-1995 of release

Repair and car operation


W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
- FUEL SYSTEM
   9.2. General information
   9.3. The air filter and a filtering element
   9.4. The block of adjustment of temperature of air arriving in the engine
   9.5. Fuel pump
   9.6. Fuel level sensor
   9.7. Fuel tank
   9.8. Accelerator cable
   + 9.9. STROMBERG 175 CDT carburetor
   + 9.10. PIERBURG 2E-E carburetor
   9.11. Removal and carburetor installation
   9.12. Inlet collector
   9.13. Heater of an inlet collector
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS



помощь ставки, помощь по ставкам на спорт.

9.13. Heater of an inlet collector

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect the electric socket from a heater of an inlet collector.
3. At existence unscrew, and remove an arm of support of an inlet collector.
4. Unscrew screws and remove a heater from an inlet collector. Remove laying and a sealing ring.

Installation

PERFORMANCE ORDER
1. Establish on a heater a new rubber ring and a sealing ring.
2. Establish a heater on an inlet collector and screw screws.
3. Connect to a heater the electric socket, then establish an arm of support of an inlet collector.
4. Connect a weight wire to the accumulator.