Mercedes W124

since 1985-1995 of release

Repair and car operation



W124 Mercedes
+ Governing bodies and control devices
+ MAINTENANCE
+ 2. Maintenance (diesel engines)
+ ENGINE
+ 4. Repair of 6-cylinder petrol SOHC engines
+ 5. Repair of 6-cylinder petrol DOHC engines
+ 6. Repair of the diesel engine established in the car
+ 7. Major maintenance of engines
+ COOLING SYSTEM
- FUEL SYSTEM
   9.2. General information
   9.3. The air filter and a filtering element
   9.4. The block of adjustment of temperature of air arriving in the engine
   9.5. Fuel pump
   9.6. Fuel level sensor
   9.7. Fuel tank
   9.8. Accelerator cable
   + 9.9. STROMBERG 175 CDT carburetor
   + 9.10. PIERBURG 2E-E carburetor
   9.11. Removal and carburetor installation
   9.12. Inlet collector
   9.13. Heater of an inlet collector
+ 10. System of injection of BOSCH CIS-E fuel (KE-JETRONIC)
+ 11. System of injection of BOSCH HFM fuel
+ 12. Fuel system of diesel engines
+ 13. Fuel system of diesel engines
+ SYSTEMS OF START, IGNITION
+ 15. System of ignition of 4-cylinder petrol engines
+ 16. System of ignition of four-cylinder petrol engines
+ PRESTARTING HEATING
+ TRANSMISSION
+ 19. Mechanical transmission
+ 20. Automatic transmission
+ POWER SHAFTS
+ BRAKE SYSTEM
+ SUSPENSION BRACKET
+ BODY
+ ELECTRIC EQUIPMENT
+ CHECK OF MALFUNCTIONS






9.5. Fuel pump

Removal

Removal of the fuel pump from the engine

Extraction of a pusher of a drive of the fuel pump

Removal of the sealing block of the fuel pump

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Establish under the fuel pump the container with rags. Mark the fuel hoses connected to the fuel pump. Weaken collars and remove submitting and returnable fuel hoses from the fuel pump.
3. Unscrew nuts and remove the fuel pump from the engine (see fig. Removal of the fuel pump from the engine).
4. Take a pusher and remove condensing block (see fig. Extraction of a pusher of a drive of the fuel pump, Removal of the sealing block of the fuel pump).
5. Check a condition of sealing rings of round section and, if necessary replace them.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Establish a pusher so that the lock ring on a pusher was from the fuel pump. Before installation of the fuel pump check freedom of moving of a pusher in the condensing block.